Cleaning Process
Chemical cleaning process removes resin debris from the internal copper surfaces of a drilled hole in a multilayer circuit board. The desmear operation ensures that the subsequent plating layer makes a reliable electrical connection with every internal signal plane. Without this step, the heat from the drilling process melts the epoxy resin and spreads it across the copper faces.
Processing Cycle
Permanganate solutions oxidize the resin residues to leave a clean and slightly textured surface on the hole wall. During a typical desmear sequence, the board passes through a sweller to soften the resin before entering the oxidant bath. Neutralization then removes the manganese ions to prevent contamination of the electroless copper line.
Proper control of the bath chemistry prevents the over-etching of the dielectric material.
Surface Quality
Plasma treatment offers a dry alternative for materials that resist chemical attack. Using high-frequency energy, the desmear equipment generates a reactive gas that vaporizes the organic matter. This method provides superior uniformity in high-aspect-ratio holes where liquid chemistry might not penetrate effectively.
Interconnect Integrity
Verification of the process occurs through microsection analysis of the plated through holes. If the desmear fails to clear the copper, the resulting separation causes intermittent failures when the board expands under thermal load.