Stress Transfer
Mechanical fasteners exert localized compressive loads that propagate into internal transducer sensing elements during installation. Excess mounting torque strain distorts the geometry of sensor housings, creating unwanted baseline offsets and output non-linearity. This structural interference degrades measurement accuracy before operational loads are applied.
Housing Deformation
Threaded fasteners, mounting flanges, and rigid baseplates transmit clamping forces directly into the instrument body. When tightening torque exceeds the design threshold, the structural shell surrounding the internal strain elements deforms elastically or plastically. This deformation shifts the physical alignment of internal wheatstone bridge arms, generating parasitic voltage outputs.
Zero Shift
Uncalibrated clamping forces produce immediate output changes that mimic actual physical measurements. Digital signal processing can zero out static installation offsets, but cannot correct the altered sensitivity scale factor resulting from structural strain.
Installation Protocol
Sensor installation guidelines mandate strict adherence to specified bolt torque values using calibrated torque wrenches. Over-tightening deforms metal diaphragms and ceramic substrates, inducing permanent micro-cracks or hysteresis in high-precision transducers. Utilizing spherical washers, torque-limiting fasteners, and isolation gaskets minimizes parasitic stress transfer to sensitive internal structures.
Quality control procedures mandate checking zero-point stability before and after fastener tightening to verify structural isolation. Field verification confirms that installed sensors remain within calibrated zero-offset allowances prior to system commissioning.