Structural Change
Mechanical deviation of a fixed support point relative to its nominal substrate coordinates defines a positional error in microelectromechanical systems. Thermal expansion or residual stress in the die attach material causes anchor displacement, leading to zero-point offsets in the sensor output. This movement represents a mechanical error that overrides the electrical calibration if the mounting surface undergoes warpage.
Displacement Measurement
Optical interferometry or scanning electron microscopy provides the primary method for quantifying sub-micron shifts in the support structure. Verification occurs during temperature cycling where the anchor displacement is tracked against a reference fiducial on the silicon frame. These observations confirm whether the bond pads remain within the design window for electrical interconnects.
The process requires a stable temperature chamber to isolate thermal noise from actual structural movement.
Drift Rate
Long-term instability in the device output often stems from the gradual relaxation of interfacial stresses at the anchor site. While the initial calibration accounts for fixed offsets, a creeping anchor displacement introduces a non-linear drift that requires periodic re-zeroing of the measurement chain. Polymer-based adhesives show higher rates of this movement than eutectic bonding techniques because the glass transition temperature affects the structural rigidity of the joint.
Drift increases with heat.
Mechanical Limit
Foundries specify a maximum allowable translation of the fixed members to ensure the resonant frequency of the suspended mass stays within a defined bandwidth.