Sensitivity Deviation
Measurement accuracy is often compromised by the influence of ambient temperature changes on sensor electronics. Thermal scale drift is the change in the sensitivity slope of a transducer caused by variations in the operating temperature. This phenomenon affects the gain of the system, meaning that the measurement error increases proportionally with the applied input.
Unlike a zero offset which shifts the baseline, this effect alters the scaling factor of the conversion.
Error Mechanism
Resistor value shifts and semiconductor bandgap variations within the amplifier stage are the primary drivers of this behavior. When the circuit heats up, the internal gains of the analog components deviate from their calibrated values. This deviation creates a proportional scaling error that is most pronounced at the full-scale limit.
Compensation Technique
Sensing elements are frequently paired with compensation resistors that possess an opposite temperature coefficient. Software correction algorithms use integrated temperature sensors to apply a dynamic correction factor to the digital output. This dual-method approach reduces the scaling error across the entire operating range.
Verification Standard
Calibration laboratories use environmental chambers to measure these effects across the specified temperature range. Sensors are cycled through several temperature steps while subjected to known reference inputs to quantify the error. The resulting data sheet specifies the maximum drift value in parts per million per degree Celsius.