Contaminant Path
Parasitic conduction paths across the exterior of an insulating material occur when contaminants or moisture create a resistive bridge between two conductors. The presence of surface leakage reduces the insulation resistance of a printed circuit board and interferes with low current measurements. This current flow bypasses the intended circuit path and introduces an offset error.
Measurement precision drops when the environmental humidity rises.
Environmental Influence
Cleanliness standards in manufacturing aim to remove ionic residues that facilitate this conduction. Residues from flux or handling attract water molecules from the air to form a conductive layer. The magnitude of surface leakage depends on the distance between conductors and the surface tension of the liquid.
Mitigation Strategy
Guarding techniques provide a physical solution to current loss by diverting the unwanted flow to a low impedance return. A conductive trace placed between high impedance nodes is held at a potential that matches the signal level. This approach effectively cancels the voltage drop that drives the leakage across the surface.
Board designers must ensure that the guard trace is not covered by solder mask to maintain its effectiveness. The placement of these traces requires careful layout to avoid increasing parasitic capacitance. Using high quality dielectric materials also helps to maintain high surface resistance under varying conditions.
Measurement Error
Characterization of this effect involves testing the board in a humidity chamber to observe the change in resistance. A high surface leakage level makes it impossible to calibrate sensitive instruments. Engineers set the acceptable limits for this error based on the accuracy requirements of the measurement system.