Localized Intensity
Mechanical phenomena in structural analysis describe the localized increase in stress near a discontinuity or a sudden change in geometry. A stress concentration occurs at sharp corners, holes, grooves, or notches where the load lines are forced to crowd together. It is a primary cause of fatigue failure and mechanical deformation in sensor housings and brackets.
Shape Factor
Engineering design seeks to minimize these peaks by using fillets and smooth transitions to distribute the force. The ratio of the maximum local stress to the nominal average stress is known as the stress concentration factor. This value depends entirely on the geometric shape of the component rather than the specific material properties.
Structural Vulnerability
Brittle materials are more susceptible to the effects of these intense local loads because they cannot yield to redistribute the stress. In a sensor diaphragm, a stress concentration can lead to premature cracking or a permanent shift in the calibration zero point. Careful machining and polishing of the surfaces reduce the presence of micro-notches that act as starting points for fatigue cracks.
During the sourcing of machined components, the minimum radius of internal corners is often specified as a critical tolerance for the supplier. If the radius is too small, the part may fail during the thermal expansion caused by power dissipation.
Stress Mapping
Finite element analysis provides a visual representation of these force gradients. This simulation allows designers to optimize the geometry before the prototype stage to ensure long term reliability.