Precision Deviation
Discrepancies between the output of a sensor and the value predicted by the ratio of the supply voltage to the measured quantity degrade the accuracy of an analog system. Measurements suffer from ratiometric error when the sensor response does not scale perfectly with changes in the excitation source. This phenomenon is common in bridge-based transducers and potentiometric circuits.
Supply Sensitivity
Changes in the reference voltage should ideally be cancelled out by the proportional change in the sensor output. When ratiometric error is present, a one percent shift in the supply results in a shift in the reported value that is not exactly one percent. This mismatch introduces a gain error that varies with the environment.
High-quality voltage regulators are used to minimize the source of this problem.
Linearity Impact
Non-linear behavior across the operating range of the sensor complicates the correction of these deviations. Designers quantify ratiometric error by measuring the output at different supply levels while holding the physical input constant. The resulting data shows the extent to which the device deviates from the expected linear response.
Software compensation can reduce the effect if the error is repeatable.
Measurement Boundary
Limits on the input voltage range define the region where the ratiometric relationship is most stable. Exceeding these bounds increases the ratiometric error as the internal circuitry reaches its saturation limits. Operating within the specified range is necessary to maintain the validity of the calibration.