Bus Architecture
Two-wire peripheral sensor interface standard enables digital data transmission from automotive sensors to central electronic control units. Developed for airbag and powertrain applications, psi5 uses variable current modulation over a twisted pair to transmit sensor readings while providing DC operating power over the same wires. The interface operates without extra shield wires in high electromagnetic noise environments.
Base voltage supplied by the control unit powers the remote sensor circuitry continuously.
Transmission Protocol
Data modulation occurs when the sensor modulates its supply current between low and high current levels to encode binary values. Physical layer specification of psi5 establishes data transmission rates of one hundred twenty-five kilobits per second or two hundred kilobits per second using Manchester encoding. Manchester coding guarantees frequent current transitions, allowing the control unit receiver to extract clock timing directly from incoming data streams.
Synchronous, asynchronous, and parallel bus topologies allow flexible connection of multiple acceleration or pressure sensors to a single transceiver port. Frame structures include parity bits or cyclic redundancy checks to detect transmission errors caused by electromagnetic interference. Timing jitter during current transitions alters bit decode windows, demanding tight clock tolerance within sensor integrated circuits.
Sensor Interface
Sensor nodes modulate current pulses onto the supply line while drawing quiescent operational current. Interfacing via psi5 requires low internal capacitance to maintain steep current pulse rise and fall times. Line impedance mismatches distort current waveforms, increasing receiver bit error rates.
Diagnostic Capability
Control units continuously monitor static supply current and dynamic pulse levels to identify sensor and wiring faults. Fault detection in psi5 systems identifies open circuits, short circuits to ground, and battery short conditions within predefined detection response times. Internal diagnostic bits embedded in frame footers signal internal sensor self-test failures to the ECU.