Physical Geometry
A transmission line configuration consists of a central signal conductor flanked by two ground planes on the same side of a dielectric substrate. Using a coplanar waveguide simplifies the integration of active and passive shunt components because it removes the need for through-substrate vias. The characteristic impedance is determined by the width of the central strip and the gap distance to the lateral ground planes.
This structure allows designers to maintain consistent impedance while varying line dimensions to match component pads.
Propagation Mode
Electromagnetic energy travels primarily in a quasi-tem mode along the gaps. Ground-to-ground spacing must be kept small relative to the wavelength to suppress higher-order modes that introduce dispersion. If the ground planes are unequal in potential, an unwanted slotline mode can emerge, which degrades signal integrity.
Engineers place metal bridges or air bridges across the signal trace at regular intervals to equalise the ground potential.
Loss Mechanism
Dielectric and conductor losses limit the performance of high-frequency transmission structures at millimetre-wave bands. Current crowds near the edges of the signal line and the ground planes due to the concentration of electric field lines. This phenomenon increases resistance and produces thermal dissipation.
Manufacturing Constraint
Printed circuit board fabrication tolerances limit the minimum achievable gap width and conductor thickness. Variations in etching can alter the gap dimension by several micrometres, causing impedance to deviate from the nominal fifty-ohm design value. Substrate surface roughness also contributes to conductor losses at high frequencies.
Fabricators measure these deviations using time-domain reflectometry to ensure the manufactured trace meets the specified transmission requirements.