Signal Saturation
Nonlinear transmission characteristics in electronics and transducers lead to a reduction in incremental sensitivity as the input signal approaches the limits of the operating range. In high-frequency and high-dynamic-range amplifiers, third order gain compression occurs when the output amplitude falls below the ideal linear value due to odd-order non-linearities in the active components. This behavior is characterized by the output power level where the gain has decreased by a specific amount, typically one decibel.
The onset of this compression defines the upper limit of the linear dynamic range of the system. Beyond this boundary, further increases in input do not produce proportional changes in the output, which introduces harmonic distortion and signal clipping.
Physical Mechanism
Voltage supply limitations in the active transistors drive the non-linear behavior under large signal excitation. When the input signal swing becomes large, the transistor operates closer to its saturation region, reducing the transconductance. This reduction is represented by the third order gain compression coefficient in the transfer function.
This behavior is a fundamental physical limitation of the amplifier circuit and cannot be eliminated without increasing the supply voltage.
Testing Procedure
Swept-power frequency measurements are performed to determine the one-decibel compression point of the device. Engineers apply an input signal of increasing power while measuring the gain of the amplifier at a fixed frequency. This test identifies the exact point where third order gain compression begins to affect the output signal.
The resulting data is recorded in the device datasheet as a primary specification.
System Consequence
Intermodulation distortion represents the primary system-level consequence of gain compression in multi-carrier systems. When multiple frequencies are present, third order gain compression causes the signals to mix, generating in-band distortion products that cannot be filtered out. This mixing degrades the signal-to-noise ratio of the receiver.
Proper gain-staging of the signal chain is required to keep the signals well below the compression point.