Thin Film Force
An internal mechanical force is present in deposited silicon nitride layers on a silicon substrate. This force, known as silicon nitride stress, can be either tensile or compressive depending on the deposition parameters. The boundary of this force is the cracking limit for tensile films, or the buckling limit for compressive films, both of which cause physical failure of the wafer.
Deposition Influence
The method used to deposit the film determines the magnitude and direction of the force. High-frequency plasma-enhanced chemical vapor deposition usually creates compressive stress, while low-pressure chemical vapor deposition produces high tensile stress. By adjusting the frequency of the plasma or the ratio of precursor gases like silane and ammonia, engineers can tune the silicon nitride stress to match the needs of the sensor structure.
Device Impact
High stress values in thin films warp the wafer, making it difficult to perform subsequent photolithography steps because the surface is not flat. Furthermore, silicon nitride stress can distort the thin silicon membranes used in pressure sensors, causing a shift in their zero-point calibration and reducing their sensitivity. Controlling this force is therefore necessary to ensure consistent device performance.
Metrological Monitoring
Engineers measure wafer curvature before and after deposition to calculate the film stress using the Stoney equation.