Interface Degradation
Time dependent degradation of the electrical interface between a semiconductor and a metallic lead. Within microelectronic sensors, ohmic contact aging leads to an increase in contact resistance and a potential loss of linearity in the signal output. This process involves the diffusion of atoms across the junction and the formation of intermetallic compounds that disrupt the flow of charge carriers.
High temperatures and electrical stress accelerate these chemical changes, eventually compromising the reliability of the entire device. The rate of degradation is also influenced by the mechanical stress at the interface, which can lead to micro cracking and further resistance increases.
Resistance Shift
Measurement accuracy suffers when the voltage drop across the interface fluctuates unexpectedly. During ohmic contact aging, the resistance may rise by several orders of magnitude, causing the sensor to drift away from its factory calibration. This change is often non linear and difficult to predict without detailed material modeling.
Gold or platinum metallization is used to slow down the rate of oxidation at the junction.
Failure Mechanism
Electromigration occurs when high current densities move metal atoms in the direction of the electron flow, creating voids in the contact area. Continuous ohmic contact aging results in these voids growing until the connection becomes intermittent or fails completely. Environmental moisture can also trigger galvanic corrosion if dissimilar metals are used in the stack.
Hermetic packaging is the primary defense against such atmospheric interference.
Stability Verification
Accelerated life testing involves subjecting the contacts to extreme heat and current to simulate years of operation in a few weeks. The progress of ohmic contact aging is monitored by measuring the contact resistance at regular intervals using a four point probe method. Designers set a maximum allowable resistance increase that the contact must not exceed during its service life.
Regular auditing of the manufacturing process ensures that the thin film deposition parameters remain within the limits required for stable junctions.