Characterization Capability
Depth-sensing indentation probes the mechanical properties of materials at the sub-micrometre scale by applying extremely small loads. Scientists use nanoindentation to measure the hardness and Young’s modulus of thin films or individual phases within a complex microstructure.
Hardware Precision
Electromagnetic or electrostatic actuators control the applied force while capacitance sensors monitor the resulting displacement with nanometre resolution. The indenter tip is typically a Berkovich diamond, which is a three-sided pyramid designed for self-similarity at different depths. Thermal drift must be monitored and subtracted from the data to ensure accuracy during long test cycles.
Analytical Model
Calculation of the contact area relies on the Oliver-Pharr method, which uses the initial slope of the unloading curve. This model assumes that the unloading phase is purely elastic and that the indenter geometry is perfectly known. Errors in the tip area function or the frame stiffness correction lead to large inaccuracies in the final modulus values.
Boundary Condition
Surface roughness and oxide layers interfere with the initial contact detection and the subsequent area calculation. For samples thinner than one micrometre, the properties of the underlying substrate begin to influence the measurement. Sophisticated algorithms are required to separate the film properties from the composite response of the system.
Data acquired at depths less than twenty nanometres often requires specialized correction for the tip rounding effect.