Electrodeposited Coating
Pure tin electroplating possessing an irregular crystalline grain structure provides solderable, corrosion-resistant terminations on component leads and printed circuit paths. Deposition of a matte tin finish generates a non-reflective, dull gray metallic surface with typical grain sizes ranging from one to five microns. This metallurgical morphology differs fundamentally from bright tin finishes, which rely on codeposited organic brighteners that create sub-micron grains prone to high internal mechanical compressive stress.
The protective function of the finish terminates if ambient intermetallic diffusion completely converts the available free tin into brittle copper-tin or nickel-tin compounds, destroying wettability during assembly soldering.
Whiskering Prevention
Grain boundary architecture governs long-term resistance to spontaneous crystal growth known as tin whiskering. Whisker formation stems from compressive mechanical stresses generated by localized substrate intermetallic growth, coefficient of thermal expansion mismatches, and residual plating stresses. Coarse crystalline grains in the matte deposit allow internal mechanical stresses to relax through grain boundary sliding rather than driving sudden, outward whisker growth.
Application of an underlying nickel barrier layer between one point three and two point five microns thick suppresses copper-tin intermetallic growth, stabilizing stress profiles across diverse thermal environments. Post-plating baking at one hundred fifty degrees Celsius for one hour relieves remaining residual stresses within the lattice.
Wettability Decay
Intermetallic growth and atmospheric oxidation consume the usable pure tin layer over extended storage intervals. At room temperature, copper and tin atoms continuously interdiffuse across the interface, forming Cu6Sn5 and Cu3Sn intermetallic phases that eventually reach the exposed surface. When these intermetallic compounds or heavy tin oxides reach the exterior boundary, standard assembly fluxes cannot reduce them sufficiently, leading to solder de-wetting and weak joint interfaces during board population.
Moisture exposure promotes surface oxidation, expanding passivation layers that require aggressive fluxes or higher soldering temperatures to displace.
Plating Qualification
Verification standards enforce strict requirements regarding grain size, coating thickness, and internal stress measurements. Microscopic evaluation using scanning electron microscopy confirms grain dimensions remain within the prescribed one to five micron window, ensuring the complete absence of specular brighteners. Plating thickness measurements performed via X-ray fluorescence follow standards such as ASTM B568, targeting nominal thicknesses between seven and fifteen microns depending on component lead application categories.
Whisker qualification tests comply with JEDEC JESD22-A121, subjecting plated parts to prolonged temperature cycling, high-temperature storage, and high-humidity damp-heat conditions without yielding whiskers longer than fifty microns. Wetting balance solderability checks under IPC/JEDEC J-STD-002 establish wetting force milestones over time.