Stiffness Reduction
Voltage-induced reduction of the effective mechanical stiffness occurs when a biased electrode exerts an electrostatic force on a moving proof mass. In silicon microstructures, electrostatic softening acts to reduce the natural resonance frequency of the device. This effect arises because the electrostatic force gradient opposes the mechanical restoring force of the silicon spring.
Designers utilize this phenomenon to adjust the sensitivity of accelerometers or gyro sensors. By varying the DC bias voltage, the mechanical behavior of the structure can be fine-tuned dynamically.
Frequency Tuning
Precise frequency adjustment represents the primary application of this physical effect in microelectromechanical oscillators. Applying a controlled DC voltage allows the operator to combat manufacturing tolerances through electrostatic softening. This tuning capability helps match the resonant frequencies of adjacent vibrating elements.
It eliminates the need for physical modification of the silicon.
Dynamic Response
Mechanical displacement towards the drive electrode increases the electrostatic force nonlinearly. This nonlinearity can lead to mechanical instability or pull-in if the voltage exceeds a critical threshold. Careful management of electrostatic softening prevents this catastrophic latching of the proof mass.
The dynamic range is therefore constrained by the voltage limits.
Calibration Boundary
Stability limits govern the maximum usable bias voltage in resonant sensors. The onset of pull-in defines the boundaries of the operating region where electrostatic softening can be safely employed. Testing procedures determine this point by gradually increasing the bias while monitoring the output amplitude.
This safety margin is programmed into the control electronics.