Oversampling Ratio
Analog-to-digital conversion techniques that employ oversampling and noise shaping achieve high resolution at low frequencies. High precision systems use delta sigma modulation to sample the analog input at a rate much higher than the Nyquist frequency. This spreading of quantization noise across a wide band reduces the noise density in the signal bandwidth of interest, which allows subsequent stages to extract the desired information with minimal degradation.
Noise Shaping
The integrator in the feedback loop acts as a high pass filter for quantization noise while passing the signal unchanged. This mechanism shifts the noise power out of the lower frequencies into the high frequency region. The loop relies on negative feedback to drive the average error to zero.
Decimation Filtering
Digital filters process the high speed, low resolution output of the modulator to produce a high resolution signal at the original Nyquist rate. This decimation stage removes the high frequency noise that was shifted upward by the modulator. The filter must have a steep transition band.
Linearity Performance
Calibration of delta sigma converters requires stable reference voltages to ensure that the feedback DAC maintains linearity. Small imbalances in the feedback path can introduce distortion that degrades the dynamic range. Laboratories verify this behavior through spectral analysis of the digital stream.