Hermetic Cavity Enclosure
An engineered encapsulation process seals delicate micro-electro-mechanical structures inside an evacuated cavity to sustain sub-atmospheric pressure levels across the device operational lifetime. Sourcing managers evaluate vacuum packaging to guarantee low damping conditions necessary for resonant sensors, microbolometers and inertial gyroscopes. The hermetic enclosure isolates microstructures from atmospheric viscous damping, moisture degradation and volatile chemical contamination.
Its boundary covers the sealed cavity itself, including getters, cap wafers, glass frits and metallic seal rings.
Damping Suppression
Gas molecules within a sensor cavity induce viscous air damping and squeeze-film effects that attenuate the mechanical amplitude of oscillating structures. Lowering the cavity pressure into the sub-Pascal regime shifts operation from viscous continuum flow to molecular Knudsen flow, drastically cutting energy dissipation. Resonator quality factors rise by several orders of magnitude under deep vacuum, directly improving sensor resolution and signal-to-noise ratios.
For uncooled infrared microbolometers, removing gas molecules eliminates conductive and convective thermal loss paths, maximizing optical detection sensitivity.
Sealing Implementation
Wafer-level encapsulation uses glass frit bonding, eutectic metal bonding or direct silicon-to-silicon fusion under low-pressure vacuum chamber conditions. Cap wafers containing etched cavities are aligned precisely over active device wafers and bonded using elevated temperatures and mechanical clamp forces. Non-evaporable getter thin films deposited inside the cap cavity are thermally activated during the bonding cycle to chemically absorb residual hydrogen, water vapor, carbon monoxide and nitrogen.
The activated getter material traps continuously outgassing volatiles from inner cavity surfaces over decades of deployment.
Integrity Verification
Hermeticity metrology enforces strict radioisotope or helium mass spectrometer fine leak testing per standards such as MIL-STD-883 Method 1014. Finished parts face optical interferometry deflection measurements, where flexure of the thin silicon cap membrane directly tracks internal cavity vacuum level. Resonant frequency and quality-factor extraction over temperature storage screening provide indirect verification of internal pressure stability.
Devices exhibiting cavity pressure rise exceeding permissible millibar thresholds fail qualification immediately, as viscous damping erodes operational sensitivity and causes frequency shifts.