Proportionality Constant
Ratio values expressing the change in electrical resistance per unit of mechanical strain characterize the performance of a resistive sensor. Calibration certificates for foil sensors always list the strain sensitivity gauge factor because it allows the data acquisition system to convert voltage into microstrain units. Higher values indicate a more sensitive sensor that can detect smaller physical deformations.
Transduction Efficiency
Efficiency of the energy conversion process depends on the alloy used in the sensing element and the orientation of the grid. While constantan foil provides a strain sensitivity gauge factor of roughly two point one, semiconductor materials can reach values over one hundred and fifty. This difference determines whether the resulting signal requires heavy amplification or if it can be read directly by a standard voltmeter.
Bridge Configuration
Wheatstone circuits use the known value of this constant to calculate the balance of four resistive arms. When the strain sensitivity gauge factor is identical for all four sensors in a bridge, the system cancels out errors from temperature and lead wire resistance. Any mismatch in these factors between the arms will result in a non-linear output that distorts the final measurement.
Calibration Traceability
Metrology laboratories verify this value by applying a known displacement to a beam and recording the change in sensor resistance. The national standards for strain measurement require that the strain sensitivity gauge factor is determined at a specific temperature and humidity to ensure accuracy. Manufacturers provide this figure with a tolerance, typically around one percent, which must be entered into the configuration software to achieve valid results.