Material Deformation
A time-dependent change in the measured strain output of a sensor under a constant, steady load indicates a continuous relaxation within its organic binder layers. This phenomenon, known as strain gage creep, occurs because the adhesive and backing materials are viscoelastic rather than perfectly elastic. When a force is sustained, these polymer layers slowly deform, which reduces the force transmitted from the specimen to the strain-sensitive foil grid.
This results in a measured strain value that decreases over time even though the external force remains perfectly constant.
Viscoelastic Effect
Polymer molecules within the adhesive line slowly slide past one another when subjected to prolonged mechanical stress. This behavior causing strain gage creep typically runs in the opposite direction to the spring-element creep of the underlying metal transducer. By selecting materials with matching, opposing creep characteristics, manufacturers can produce transducers where the two effects largely cancel each other out.
Output Correction
Compensating for this drift is essential in long-term weighing applications such as silo monitoring or structural health testing. Knowing the rate of strain gage creep allows engineers to apply mathematical corrections to the sensor’s output over time.
Environmental Factor
Elevated temperatures and high humidity levels worsen this baseline drift by softening the adhesive bond. In humid environments, moisture absorption reduces the glass transition temperature of the epoxy, which increases the rate of strain gage creep. Standard testing is conducted in controlled laboratory environments to quantify these effects and establish the sensor’s operating boundaries under varying environmental conditions.