Output Characteristic
Internal resistance and reactance viewed from the output terminals of a signal generator or sensor determine how the device interacts with external loads. High values of source impedance result in a voltage drop when current is drawn. This parameter is a specification for matching sensors to amplifiers.
Maximum power transfer and the signal to noise ratio are defined by this value.
Loading Effect
Voltage division occurs when the input impedance of the receiver is not much higher than the source impedance. This effect reduces the signal level seen by the measuring instrument. To minimize error, the load should ideally be ten times larger than the source.
Frequency Dependency
Complex components such as capacitance or inductance in the source cause the impedance to change across the frequency spectrum. A piezoelectric sensor has a high source impedance at low frequencies. This characteristic necessitates the use of specialized charge amplifiers.
Measurement Technique
Characterization of the source involves measuring the open circuit voltage and the voltage under a known load. The difference between these two readings allows for the calculation of the internal impedance. Advanced methods use bridge circuits for higher precision.
Verification of these values is essential during the qualification of new sensing hardware.