Structural Deformation
Mechanical stress in sensor diaphragms generates cumulative strain when the material is subjected to repeated load fluctuations. This progressive deformation, termed pressure cycle creep, occurs even when the maximum applied stress remains well below the elastic limit of the material. The deformation accumulates over thousands of pressure cycles, leading to a gradual change in the shape of the diaphragm.
Metrological Influence
Progressive material shifts alter the baseline output of pressure transducers by modifying the pre-tension of the sensing element. When pressure cycle creep occurs, it causes a slow drift in the zero-pressure signal of the sensor. This drift is non-linear and depends heavily on both the frequency and amplitude of the pressure cycles.
Over time, the change in the baseline output can exceed the designated calibration limits of the device.
Mitigation Method
Heat-treating the diaphragms before assembly stabilizes the microcrystalline structure and reduces the density of mobile dislocations. High-purity materials such as fused silica are preferred because they exhibit extremely low susceptibility to cyclic strain accumulation.
Verification Procedure
Accelerated fatigue testing subjects the sensor to millions of pressure cycles while monitoring the output stability. Highly accurate reference gauges measure the zero-point displacement after each testing phase to determine the rate of structural drift.