Circuit Interface
Passive circuit configurations consisting of resistors integrated into a measurement loop adjust the span and offset of a sensor signal. Engineers implement a padding network to match the output of a raw sensing element to the input range of an analog to digital converter. This arrangement allows for the standardization of different transducers so that they present a uniform electrical interface to the control system.
Impedance Matching
Series and parallel resistors are selected based on the measured characteristics of the individual bridge. By including a padding network, the technician can attenuate a signal that is too strong or shift the zero point of a transducer that exhibits a natural bias. This hardware-based adjustment reduces the gain requirements of subsequent amplification stages.
Thermal Correction
The network is often fabricated using thin film resistors for superior thermal stability.
Response Scaling
Interactions between the padding resistors and the sensor impedance can introduce non-linearity if the values are not properly balanced. A well-designed padding network utilizes low temperature coefficient components to ensure that the compensation does not drift as the ambient environment changes. These circuits are typically found in high-reliability industrial modules where digital calibration is insufficient to correct for large hardware offsets.