Signal Attenuation
An unwanted change in the transmitted power of a high frequency signal occurs over time due to material or environmental aging. When high frequency signals propagate through a transmission line, insertion loss drift reduces the signal strength at the receiver. This performance degradation happens gradually and affects both active and passive RF components.
Environmental Driver
Fluctuating temperature and humidity levels accelerate the degradation of dielectric substrates and conductor surfaces. In humid environments, moisture absorption alters the relative permittivity of the circuit board material. These dielectric variations increase the high frequency loss tangent and shift the signal response.
Performance Change
Degrading conductor surfaces also contribute to the alteration of electrical paths through oxidation. This oxidation process increases the surface roughness of the microstrip lines and leads to a higher skin effect resistance. High frequency attenuation becomes more pronounced at elevated temperatures.
Measurement Protocol
Monitoring these fluctuations requires periodic calibration of the test system using a vector network analyzer. Technicians perform these measurements under controlled laboratory conditions to isolate the drift from external cabling movements, which would otherwise introduce measurement errors. Regular verification protects the accuracy of communication systems in long term deployments by ensuring that the initial baseline remains valid throughout the service life.