Electrical Opposition
Opposing force presented by a transmission line to an alternating current at gigahertz frequencies is a critical factor in high-speed digital layouts. This complex electrical parameter, referred to as high frequency impedance, is determined by the inductive and capacitive relationships of the conductor geometry. It remains constant along the length of a uniform trace to prevent signal reflections.
The nominal value is typically designed to match the source and load resistances of the active components.
Physical Dimension
Geometric variations in trace width, copper thickness, and dielectric spacing alter the capacitance per unit length of the transmission line. In a manufacturing environment, high frequency impedance changes when the etching process alters the trace profile from a rectangle to a trapezoid. Even a slight decrease in trace width increases the characteristic impedance.
The thickness of the surrounding solder mask also influences the effective dielectric constant and the resulting trace impedance.
Signal Deviation
Reflections occur at any boundary where the trace cross-section or spacing changes abruptly. Such discontinuities cause high frequency impedance mismatches that degrade the quality of the transmitted signal. These reflections can cause signal distortion, timing jitter, and increased electromagnetic interference.
Minimizing these deviations requires careful control of via transitions and connector solder pads.
Testing Coupon
Time-domain reflectometry instruments measure the resistance of the trace along its length by injecting a fast-rise-time step pulse into the circuit. This measurement identifies the high frequency impedance profiles of the trace and shows the location and magnitude of any mismatch. Coupon testing at the edge of the panel allows manufacturers to verify the impedance without probe-damaging the functional board traces.
The measured values must fall within the specified tolerance band, which is usually ten percent of the target impedance, before the boards are approved for component assembly. These results are recorded on the certificate of conformance delivered with the production lot to ensure compliance with the design specifications.