Post-Package Adjustment
Digital calibration adjustment via a two wire interface enables the fine tuning of internal voltage or current sources after the device is packaged. This i2c reference trim compensates for shifts induced by the heat of the assembly process. It targets the small errors in the bandgap voltage that occur when the silicon die experiences mechanical stress from the molded plastic housing.
Command Protocol
Communication occurs through the serial data and serial clock lines to modify non volatile memory registers. Every i2c reference trim operation requires a specific sequence of start conditions followed by the device address and a command byte. The master controller sends a bit pattern that increases or decreases the effective resistance in a ladder network.
This modification changes the gain of the output buffer until the measured value aligns with the target specification.
Production Impact
Post package adjustment reduces the scrap rate by allowing units that fell slightly out of tolerance to be brought back into the valid range. Because the i2c reference trim happens at the board level, it accounts for the cumulative effects of the entire manufacturing chain. High volume production lines use automated test equipment to perform this step in milliseconds per unit.
Verification Step
Verification involves a final read back of the modified registers to confirm successful write operations. A stabilized supply voltage ensures that the new setting remains valid across the operating life of the circuit.