Bus Topology
Hardware activation protocols establish valid electrical states and protocol handshakes across a two-wire serial interface during initial board commissioning. Systematic I2C bus bring-up verifies signal integrity on serial data and serial clock lines before high-level driver software attempts peripheral transactions. The procedure governs open-drain bus pull-up sizing, line capacitance limits and master-slave addressing compliance.
It ends once physical layer signaling meets bus timing specifications.
Signal Verification
Oscilloscope measurement of clock and data rise times reveals whether passive pull-up resistors match total bus capacitance. During I2C bus bring-up, improper resistor values create rounded edges that violate logic high thresholds or cause excessive current consumption when drivers pull lines low. Bus timing parameters including setup time, hold time and clock low period must be verified against component datasheets under maximum capacitive loading conditions.
Signal reflection and ground bounce can corrupt data frames if trace routing lacks adequate impedance control.
Electrical Noise
Crosstalk between adjacent high-speed signal lines introduces transient voltage spikes onto open-drain clock lines. False clock edges trigger unwanted bus arbitration losses or lock peripheral state machines into indefinite wait states.
Acceptance Standard
Logic analyzer traces confirm successful acknowledge bits across all populated device addresses. The qualification phase terminates when bus error counters remain at zero during sustained multi-master write operations.