Frequency Response
The ratio of an instrument’s electrical output variation to the dynamic change in physical excitation defines its frequency-dependent responsiveness. Dynamic sensitivity characterizes sensor behavior under fluctuating, periodic or transient physical loads across a defined spectral bandwidth. Piezoelectric accelerometers, dynamic pressure transducers and dynamic force sensors exhibit sensitivity values that vary with excitation frequency and structural damping.
The specification stops applying when excitation frequencies exceed the first mechanical resonance of the assembly, where nonlinear mechanical amplification and structural phase inversion destroy measurement validity.
Mechanical Action
Internal mass, stiffness and damping govern how the sensing element transforms rapid physical inputs into electrical charges. As the excitation frequency approaches the natural resonance frequency of the transducer, mechanical amplification causes the apparent sensitivity to rise sharply above its static or reference value. Near resonance, small increments in physical input velocity or acceleration produce disproportionately large charge distributions across the piezoelectric crystal.
Signal conditioners with finite input impedance introduce high-pass filtering effects that roll off sensitivity at low frequencies, dictating the lower cut-off limit. Operating outside the flat response region requires correction curves to rescale output amplitudes accurately.
Environmental Alteration
Ambient temperature swings shift sensor resonance frequencies by altering the mechanical stiffness of internal flexures and piezoelectric substrates. The change in dynamic sensitivity alters measurement values even when external excitation amplitude remains strictly constant. Mounting torque variations introduce mechanical compliance between the sensor base and the test structure, shifting the mounted resonance downward into the intended operational bandwidth.
Cable capacitance alters the effective sensitivity of high-impedance charge-mode transducers by attenuating signal amplitude before charge amplifiers process the voltage. Surface roughness at the mounting interface compounds high-frequency measurement loss.
Calibration Metric
Primary metrology laboratories establish dynamic sensitivity by mounting the transducer onto an electrodynamic shaker coupled with a laser Doppler vibrometer reference. The shaker sweeps through the operational frequency band while data acquisition systems measure the sensor output voltage against the laser-derived acceleration reference according to ISO 16063-21. Calibrated values are plotted as amplitude ratios across frequency, defining the working bandwidth where deviation remains within tight tolerances such as plus or minus five percent.
Recertification protocols check for internal crystal cracking or flexure fatigue by comparing measured dynamic sensitivity profiles against baseline factory records. Verification fails when sensitivity shifts beyond agreed quality criteria.