Numerical Processing
Electronic refinement of sensor outputs converts raw voltage levels into accurate, linear representation of physical measurements. Through digital signal conditioning, an embedded processor applies mathematical formulas to the digitized data to remove noise and compensate for non-linearities before scaling the measurements to engineering units. This processing takes place after analog-to-digital conversion, and it requires a high-resolution input to avoid quantization errors.
Correction Algorithm
Temperature compensation is a primary task of these systems. Digital signal conditioning utilizes calibration matrices stored in non-volatile memory to adjust the active reading based on a secondary temperature sensor. This step eliminates thermal drift across a wide operating envelope.
It operates in real time during continuous measurement.
Hardware Execution
Microcontrollers execute the conditioning tasks in digital sensor systems. Low-power digital signal conditioning algorithms run within the sensor housing to minimize transmission noise over long cable runs. This proximity ensures that the transmitted signal is already corrected and ready for use by industrial control networks, which simplifies the overall system architecture.
The timing of this processing must not introduce excessive latency.
Filter Boundary
Noise reduction is limited by filter bandwidth. Oversampling allows digital signal conditioning to achieve higher resolution by spreading noise over a wider frequency band.