Signal Processing
Mathematical compensation algorithms executed during mechanical testing isolate the true deformation of a test specimen from the elastic deflection of the instrument frame and load train. A compliance correction subtracts the load-dependent displacement of grips and drive columns from raw transducer readings. In micro-indentation and high-stiffness tensile testing, compliance correction prevents overestimating sample strain by ensuring that load-frame elasticity does not skew calculated modulus values.
The correction applies up to the elastic limit of the instrument structure, beyond which non-linear mechanical deformation voids the calibration model. Precise compensation relies on prior baseline measurements where load cell output is plotted against crosshead position using a rigid calibration block.
Fixture Strain
High-force mechanical testing mounts introduce elastic flexure within hydraulic grips and load transducers. Applied forces generate small load train deformations that displacement sensors register as specimen elongation, leading to carrier measurement errors.
Calibration Routine
Metrology standards specify baseline compliance determination using ultra-stiff tungsten carbide blocks. During calibration, compliance correction curves are fitted to force-displacement data to generate polynomials stored in sensor firmware.
Error Reduction
Subtraction of frame deflection becomes critical when testing small material volumes or thin films. Uncompensated test data yields lower modulus values than real material properties dictate. Certified testing procedures require verified compliance parameters for every grip configuration.