Viscoelastic Representation
Mechanical systems use a combination of springs and dashpots to describe the behavior of a real solid. The zener model, also known as the standard linear solid, accounts for both the instantaneous elastic response and the time-dependent creep of a material. It consists of a linear spring connected in parallel with a Maxwell element.
Stress Relaxation
Load application results in an initial peak stress that decays over time toward a non-zero equilibrium value. The zener model captures this transition by allowing the dashpot to dissipate energy while the parallel spring maintains the structural integrity. This behavior accurately represents the damping seen in many polymers and metals at low strain.
Dynamic Response
Frequency-dependent stiffness occurs because the internal fluid-like element cannot react instantly to rapid changes. In the zener model, the storage and loss moduli vary with the frequency of the applied vibration. At very high frequencies, the dashpot effectively locks, and the material appears stiffer than it does under static conditions.
This frequency sensitivity is a primary consideration when selecting materials for vibration isolation mounts.
Model Verification
Creep tests and dynamic mechanical analysis provide the data needed to determine the model constants. The zener model is verified by comparing the predicted phase lag between stress and strain to the measured values from a rheometer. It fails to describe the system once the deformation enters the non-linear or plastic regime.