Mechanical Failure
The gradual weakening and eventual fracture of a conductive path on a circuit board results from repeated mechanical or thermal stress cycles. Trace fatigue typically begins with the formation of microscopic cracks at points of high stress concentration like sharp corners or solder pads. Cracks grow slowly.
Over time, these cracks propagate through the cross section of the copper until the connection becomes intermittent or fails completely.
Stress Origin
Vibrations in industrial machinery or the expansion and contraction caused by power cycling provide the energy required for crack growth. In flexible electronics, trace fatigue is the primary factor limiting the operational life of the device. Using wider traces or rounded corners can help distribute the load and delay the onset of structural damage.
Material Influence
The ductility of the copper foil determines its resistance to the accumulation of plastic deformation during each cycle. Soft materials like rolled annealed copper offer better protection against trace fatigue than harder, electrodeposited varieties. Testing involves subjecting the board to accelerated life cycles in a specialized bending jig to determine the expected time to failure.
Detection Method
Continuous monitoring of the electrical resistance can identify the early stages of a fracture before a complete open circuit occurs. As trace fatigue progresses, the resistance of the path will increase slightly due to the reduced cross sectional area at the crack site. Measurements provide a clear warning.
This data allows for the replacement of critical components during scheduled maintenance to avoid an unexpected system shutdown that could damage other parts of the machine and lead to expensive repairs for the facility.