Adhesion Failure
Layered materials and coated sensors can experience mechanical separation of the deposition layer from the underlying substrate. This thin film delamination degrades both the mechanical protection and the electrical continuity of the device. It often occurs when the adhesion strength at the interface is lower than the internal stresses.
Stress Concentration
High residual stresses generated during the deposition process or thermal expansion mismatches between materials drive the separation. These stresses cause thin film delamination to initiate at defects, edges, or areas of contamination. Once initiated, the crack propagates along the interface between the film and the substrate.
Metrological Detection
Acoustic microscopy and nanoindentation are used to detect and quantify the onset of interface separation in semiconductor and sensor manufacturing. Because thin film delamination may be microscopic, checking the thermal response or the changes in electrical resistance helps identify the defect before a complete structural failure occurs. These test methods are part of the quality assurance process for thin-film pressure sensors, where even a tiny void can alter the piezoresistive behavior of the transducer under high-pressure conditions.
Prevention Strategy
Applying an adhesion-promoting layer before depositing the main film increases the bonding strength. Controlling the substrate temperature also reduces residual stress.