Transduction Principle
Microelectromechanical systems exploit the resistance change of crystalline structures under mechanical load to convert physical pressure into electrical signals. Transducers based on piezoresistive silicon MEMS integrate doped resistors directly into a thin silicon diaphragm that deforms when exposed to fluid or gas pressure. This deformation alters the resistivity of the silicon, creating a measurable electrical signal that is proportional to the applied force.
It is the primary mechanism used in industrial pressure transmitters.
Sensor Fabrication
Manufacturing of these sensors uses standard semiconductor processes like photolithography and chemical etching to create the microstructures. The resistors are formed by ion implantation on the surface of the silicon membrane. This approach ensures high consistency across multiple production batches.
Temperature Dependence
Thermal sensitivity changes the resistance of the silicon even in the absence of mechanical strain, creating a signal error. To prevent measurement inaccuracy, the sensor must be used with compensation circuitry that counters this thermal shift.
Signal Conditioning
Analog front-end electronics amplify the microvolt-level signals from the sensor and convert them into digital outputs. A Wheatstone bridge configuration balances the output and reduces common-mode noise, while digital calibration parameters correct for non-linear behavior. This conditioning ensures that the final pressure value remains accurate across the entire operating temperature range.