Interconnect Method
Vertical connection strategy using small diameter laser-drilled holes to route signals from a high-density component to internal board layers. Most high-density designs use a microvia escape to enable the use of fine pitch components where standard mechanical drilling is physically impossible. It stops at the interface between the top copper pad and the first or second buried layer of the substrate.
Density Improvement
Reduced pad sizes allow for more routing channels between vias. This microvia escape strategy increases the total connection density by an order of magnitude compared to traditional through-hole methods.
Via Structure
Reliability depends on the aspect ratio and the quality of the plating inside the small hole. Stacked or staggered configurations allow a microvia escape to penetrate deeper into the board stackup. Fabrication limits often restrict the depth of these vias to a single dielectric layer to ensure consistent copper deposition.
Stub Reduction
Shorter vertical transitions reduce parasitic inductance which improves the performance of high-speed data links. The microvia escape minimizes the stub length that typically causes signal reflections in through-hole designs. Careful control of the drilling laser prevents damage to the target land and ensures a low resistance contact.
These features make it the preferred choice for mobile devices and high-performance computing modules where space and signal quality are both at a premium.