Conditioning Architecture
Electronic circuits that convert high-impedance charge signals from piezoelectric transducers into low-impedance voltage signals enable the monitoring of dynamic physical forces. The charge amplifier uses a high-gain operational amplifier with a feedback capacitor to integrate the incoming current. Because the input impedance is extremely high, the circuit effectively collects every electron generated by the sensing crystal.
This approach makes the measurement independent of the cable length between the sensor and the processing electronics.
Feedback Loop
Capacitance values in the feedback path determine the gain of the entire stage and the resulting output scaling. A small feedback capacitor results in high sensitivity for low-level signals, while a larger capacitor allows the charge amplifier to handle high-magnitude shocks without saturating the output. High-quality capacitors with low leakage are necessary to maintain signal integrity over long measurement periods.
Insulation resistance across this component must exceed several teraohms to prevent the charge from bleeding away prematurely.
Time Constant
Low-frequency response limits the ability of the system to measure static or slowly changing events. The time constant of the charge amplifier is the product of the feedback resistance and the feedback capacitance. Short time constants allow for rapid recovery after a large impulse but filter out the low-frequency components of the signal.
Drift Mitigation
Bias currents within the operational amplifier slowly accumulate on the feedback capacitor and cause the output voltage to move away from zero. A reset switch or a very high-value resistor is placed in parallel with the capacitor to periodically clear this accumulated charge. This discharge process prevents the charge amplifier from reaching its voltage rails during continuous operation.
Environmental temperature changes often accelerate this drift by increasing the leakage currents within the semi-conductor materials.