Physical Failure
An unintended conductive path between two or more electrical nodes on an integrated circuit alters the logical behaviour of the network. This bridge defect occurs during manufacturing when excess metal, particle contamination, or incomplete etching leaves a physical connection between adjacent lines. Signal integrity suffers because the node voltages are no longer independent.
Diagnostic Isolation
Electrical testing of these faults relies on identifying intermediate voltage levels or unexpected logical states during scan operations. When two signal paths are shorted, the resulting logic level depends on the drive strengths of the opposing transistors. Static current measurements often assist in locating these nodes because the short-circuit condition increases the current draw of the device.
This leakage current is measured during specific clock cycles to isolate the failing node pair.
Structural Model
Simulating the behaviour of shorted lines requires modeling the node interaction as a wired-AND or wired-OR relationship. Complex circuits can display state-dependent bridging where the fault only appears under specific voltage conditions or when adjacent lines carry high frequencies. Inductive effects and capacitive coupling can further complicate the identification of these paths during high-speed testing.
Validation Control
Screen limits for bridging faults are verified during production wafer sort by applying targeted test patterns. Automatic test pattern generation software creates vectors that drive the shorted nodes to opposite logic values to expose the failure.