Extrusion Resistance
Anti extrusion devices prevent the migration of a primary elastomer seal into the clearance gap between mating parts under high pressure conditions. A backup ring is typically installed on the downstream side of an O ring to provide a rigid barrier. It maintains the geometric integrity of the softer seal material as system loads increase.
Functional Mechanism
Geometric stability at the interface of a piston and cylinder depends on the shear strength of the sealing assembly. When a backup ring is present, it reduces the effective clearance that the primary seal encounters. This configuration allows O rings to operate at pressures that would otherwise cause permanent deformation or nibbling.
The secondary ring provides a stiff surface that the softer elastomer can press against without being forced through the small opening between the metal parts. It effectively increases the pressure rating of the entire assembly by protecting the weakest element.
Material Choice
High modulus polymers such as polytetrafluoroethylene or nylon offer the necessary stiffness to resist deformation while remaining compatible with hydraulic fluids. In extreme environments, a backup ring might be machined from metallic alloys or advanced composites. The selection process considers the thermal expansion coefficient.
Installation Bound
Groove dimensions must accommodate both the primary seal and the secondary support element without overfilling the available volume. A single backup ring protects against pressure from one direction.