Timing Parameter
AC electrical parameter defines the delay between the falling edge of a clock signal and the moment the data becomes valid on the bus. The t_sco timing is a fundamental constraint for synchronous communication as it dictates the maximum achievable clock speed. It measures the internal propagation delay of the target device as it responds to the controller.
Propagation Variable
Internal logic delays and output driver strength are the primary contributors to this value. High bus loading increases the t_sco timing because the driver takes longer to reach the necessary voltage levels. If this delay exceeds the half period of the clock, the controller will sample the data before it has stabilized.
Measurement Cycle
Verification involves using an oscilloscope with a sampling rate at least ten times the bus frequency to capture the relationship between the clock and data lines. The t_sco timing is measured from the fifty percent point of the clock edge to the point where the data signal crosses the logic threshold. Calibration of the probe tip is necessary to remove any skew introduced by the test leads.
Design Budget
Interface design requires accounting for this parameter when calculating the total timing budget. Insufficient margin leads to data corruption at higher temperatures.