Peripheral Configuration
Synchronous data storage location inside a peripheral device allows for the configuration and monitoring of hardware functions via a four wire interface. Access to an spi register involves the use of a chip select line, a clock line and two data lines for full duplex communication. It holds the control bits that determine the sample rate, the filter settings, the output format and the interrupt behavior of the sensor.
Transfer Cycle
Data transfer starts when the master pulls the chip select line low to activate the peripheral. The master then shifts an address byte into the spi register to indicate which internal memory slot is being targeted. If the operation is a read, the device shifts the requested data out on the next eight clock pulses.
Access Latency
Communication speed is governed by the maximum clock frequency supported by the hardware, often reaching tens of megahertz. Because an spi register can be accessed while other operations are pending, it provides a low latency path for real time control. This makes it superior to slower serial protocols for high speed data acquisition.
Protocol Integrity
Parity bits or checksums are sometimes included in the transaction to detect transmission errors. High reliability systems verify the contents of critical registers periodically.