Spectral Density
Input-referred voltage or current noise measured within a narrow one-hertz band represents the localized noise performance of an integrated circuit. This frequency-specific metric, termed operational amplifier spot noise, is specified at discrete frequencies such as ten hertz, one hundred hertz, and one kilohertz. It allows designers to evaluate noise performance across different parts of the signal spectrum.
Frequency Characteristic
High-precision analog designs require a clear distinction between flicker and white noise zones. The operational amplifier spot noise is high at low frequencies due to flicker noise effects, but it flattens out to a constant value at higher frequencies. This constant value is determined by the thermal noise of the internal resistors and the shot noise of the input transistors.
Measurement Circuit
Calibration labs measure this value by connecting the device under test to a high-gain amplifier with a known feedback network. The output of the circuit is connected to a spectrum analyzer that calculates the noise voltage density. Designers must select feedback resistors carefully so that their thermal noise does not mask the spot noise of the amplifier itself.
Hardware Selection
Low-frequency sensor interfaces such as seismic detectors or medical electrocardiograms demand amplifiers with low spot noise in the hertz region. If the sensor has a high output impedance, the current noise component dominates the total system noise. For low-impedance sensors, the voltage noise component is the primary factor limiting system resolution.
Measuring and verifying these values across multiple production lots ensures consistent sensitivity in high-volume laboratory and industrial measurement devices.