Circuit Topology
Transmission gate design employing a single n-channel metal-oxide-semiconductor transistor to control signal flow between nodes represents an efficient routing element in digital circuits. This nmos pass gate uses a control signal on its gate to enable or disable the path. Because it occupies less silicon area than a full transmission gate, it is widely used in multiplexers and memory arrays.
Voltage Degradation
Output voltages through this configuration cannot reach the positive supply rail due to the threshold voltage drop of the transistor. When passing a high logic level, the nmos pass gate turns off before the source reaches the gate voltage. This limitation results in a maximum output voltage equal to the gate voltage minus the threshold voltage.
Digital designs must use restorer circuits or level shifters to regain full-swing signals after this drop.
Switching Speed
Propagation delay through the channel is governed by the drain-to-source resistance and the loading capacitance of the output node. This dynamic slowdown is more pronounced at low supply voltages.
Implementation Method
Dual-rail logic or bootstrapped gate drives are applied to overcome the voltage loss and speed limitations of these structures. Bootstrapping raises the gate voltage above the supply rail during a transition, allowing the nmos pass gate to pass a full-rail voltage. This approach avoids the need for an additional p-channel device, which keeps the circuit area small.
Designers must verify that the bootstrapped voltage does not exceed the dielectric breakdown limit of the gate oxide.