Standard Foundation
International standards for measuring the mechanical vibration of rotating shafts establish unified technical specifications and calibration requirements for non-contacting eddy current displacement sensor systems. Normative guidance in iso 10817-1 defines electrical, mechanical, and metrological criteria for inductive proximity probes used across high-speed turbomachinery monitoring. The standard encompasses sensing coils, extension cables, and oscillator-demodulator drivers configured to measure shaft displacement relative to bearing housings.
Scope limits restrict the standard to non-contacting radial and axial displacement measurements on conductive ferromagnetics, excluding seismic velocity sensors and piezoresistive contact transducers.
Metrological Sensitivity
Proximity probe systems operate via high-frequency electromagnetic field interactions, producing output voltages proportional to gap distances between probe tips and target shaft surfaces. Nominal system sensitivity under iso 10817-1 defaults to seven point eight seven millivolts per micrometre across an linear measuring range spanning at least two millimetres. The probe driver excitation frequency typically operates between one and two megahertz to limit eddy current penetration depth into the rotating steel shaft.
Thermal changes within extension cables alter system resonance, shifting static output voltages unless internal temperature compensation circuits maintain stability. Electrical runout from residual shaft magnetization and mechanical runout from shaft out-of-roundness superimpose spurious voltages onto true vibration readings.
Target Metallurgy
Non-destructive proximity testing requires dedicated calibration against the exact metallurgical composition of the rotating machinery shaft. Carbon steel grades such as 4140 serve as universal factory reference materials, but differences in alloy content or surface carburization alter baseline calibration slopes significantly. Sensor drivers certified on low-alloy steel exhibit large scale-factor errors when applied directly to austenitic stainless steel shafts without recalibration.
Mechanical scratches, localized stress concentrations, and thermal spray coatings distort eddy current loops, creating apparent electrical runout signals that exceed dynamic vibration limits.
Verification Protocol
Compliance verification mandates dynamic linearity testing using precision micrometer calibration rigs combined with reference target discs. Calibration certificates report incremental scale factors, total electrical runout, and maximum linear deviation across the full displacement span. Laboratory verification demands traceable reference gauge blocks and digital voltmeters displaying uncertainties below zero point one percent of reading.
Verification intervals must encompass both the proximity probe tip and the associated matched-length driver cable, as swapping individual sub-assemblies shifts calibrated sensitivity curves beyond standard tolerance bands.