Layer Architecture
Printed circuit board interconnect structures provide electrical continuity between an outer conductor layer and internal layers without penetrating the full substrate thickness. A blind microvia created through UV laser drilling establishes connections between layer one and layer two across thin dielectric materials. IPC-2226 defines maximum aspect ratios of one to one for these microstructures to ensure reliable chemical copper deposition.
Beyond a diameter of one hundred fifty micrometres, mechanical drilling replaces optical ablation and changes the boundary of microvia classification.
Drilling Metric
Laser energy profile control establishes target pad clearing without breaching the underlying copper stop layer. Excess fluence during blind microvia formation causes target pad melt-through or thermal damage to lower dielectric strata. Precise pulse counts prevent burn-through.
Plating Tolerance
Electroplating bath chemistry determines wall coverage inside micro-cavities where fluid exchange remains restricted. Incomplete copper deposition within a blind microvia creates voiding that elevates direct-current resistance across high-frequency sensor signal channels. Inspection via microsectioning verifies target copper thickness at the capture pad interface.
Fabrication facilities test electrical continuity using four-wire Kelvin probes at room temperature to validate batch quality prior to component assembly.
Thermal Failure
Z-axis thermal expansion mismatch between epoxy resins and copper barrels induces localized stress concentration during reflow soldering cycles. The base of a blind microvia experiences shear stress at the interface between the electrodeposited copper wall and the internal target pad. Thermal cycling between minus forty degrees Celsius and one hundred twenty-five degrees Celsius highlights corner cracking issues.
Barrel separation occurs when intermetallic growth degrades adhesive strength.