Signal Processing
Signal processing hardware provides high frequency excitation to a resistive bridge circuit. The ac carrier amplifier modulates the low level transducer signal onto a sinusoidal carrier wave to eliminate the effects of direct current noise. This method isolates the measurement from thermocouple effects and electronic offsets.
Demodulation Technique
A synchronous rectifier converts the modulated signal back into a proportional voltage after filtering out the carrier frequency. Because the ac carrier amplifier operates at a specific frequency range, it ignores electrical interference from power lines and ambient sources. High signal to noise ratios result from this frequency selective amplification.
Pure sinusoidal excitation prevents the generation of unwanted harmonics that could distort the primary output signal. Filtering stages further refine the waveform to remove residual carrier ripple.
Calibration Requirement
Technicians verify the phase alignment between the excitation and the return signal to ensure linear response across the full scale. An ac carrier amplifier needs precise adjustment of the phase shift to prevent quadrature errors from introducing measurement bias. Frequency response limits the dynamic range of the data.
System Integration
Input impedance and transformer coupling define the isolation boundary for the connected sensors. The ac carrier amplifier maintains signal integrity in environments where ground loops would otherwise corrupt low level data. Stable excitation remains a prerequisite for repeatable output.