Signal Integrity
Passive electrical components inserted into high-speed digital lines control signal reflections and minimize electromagnetic interference in serial interfaces. Placing a series damping resistor spi on the clock, master-out-slave-in, and master-in-slave-out lines helps match the driver output impedance to the characteristic impedance of the transmission line. This configuration reduces ringing and overshoot caused by fast transition edges.
It is a standard design practice for buses routing across long PCB distances.
Impedance Matching
Ringing occurs when the fast output transition of a microcontroller pin encounters a high-impedance load at the receiver, causing energy to reflect back. The series damping resistor spi absorbs this reflected energy, preventing it from corrupting the incoming signal data. This damping action rounds off the sharp edges slightly, which also reduces the high-frequency noise radiated by the board traces.
In turn, this helps the product pass electromagnetic compatibility testing.
Resistor Selection
Selecting the correct resistor value requires balancing the reduction in ringing against the increase in signal rise time. Typical values range from twenty-two ohms to forty-seven ohms, positioned as close to the transmitter pins as possible. Choosing a value that is too high can cause excessive signal attenuation and timing failures.
Performance Verification
Engineers verify the effectiveness of the damping resistor by measuring the signal waveform at both ends of the SPI bus under full operating speed. This measurement is performed with a low-capacitance active probe to avoid loading the bus during the test. The resulting waveform should show minimal overshoot and a clean, flat plateau at both high and low logic states.
Adjusting the resistor value during prototype testing allows designers to fine-tune the signal quality and achieve the best balance between transition speed and noise suppression.