Signal Spuriousness
Unsolicited processor interrupt requests trigger signal handling routines without a corresponding hardware event from an active peripheral. In embedded sensor interface systems, phantom interrupts occur when electrical noise or marginal signal timing alters the state of interrupt lines near logic voltage thresholds. Electromagnetic interference from switching power supplies couples into high-impedance trace lines, creating transient voltage spikes.
Ground bounce during simultaneous output switching shifts local ground potential, triggering edge-sensitive interrupt controllers. Cross-talk between adjacent signal lines on printed circuit boards further induces spurious pulses on unshielded interrupt inputs. Fast signal transition times exacerbate inductive coupling across connector pins.
Processor Handling
Interrupt controllers read status registers to identify the asserting device after accepting an interrupt vector. When no peripheral reports a pending flag, the processor executes a default spurious interrupt service routine. Unhandled spurious events lead to system latency degradation as processor cycles spend time entering and exiting empty handlers.
Memory corruption occurs if stack pointers shift without matching interrupt exit instructions.
Hardware Filtering
Physical low-pass filters attenuate high-frequency noise spikes before signals reach microcontroller interrupt pins. Pull-up resistors enforce defined logic levels on floating input lines to prevent false state changes. Differential signaling reduces common-mode noise susceptibility on long sensor communication cables.
Dedicated bus transceivers isolate vulnerable logic lines from noisy field wiring.
Firmware Mitigation
Double-read verification checks hardware status flags inside the interrupt service routine before executing secondary code paths. Software debouncing delays vector execution until signal levels remain stable for defined clock cycles. Disabling unused interrupt vectors prevents execution of unassigned memory regions.