Shielding Line
Copper routing lines placed parallel to sensitive analog signals protect them from electromagnetic coupling and capacitive crosstalk. These lines are called guard traces, and they are typically tied directly to a quiet ground potential or driven by a low-impedance buffer at the same potential as the signal. This layout technique blocks stray electric fields that would otherwise interfere with low-level sensor readings.
Isolation Mechanism
Placing a grounded line between two signal traces interrupts the direct capacitance between them, redirecting the electric field lines to ground. In high-impedance applications, such as pH sensor interfaces or electrometer circuits, guard traces prevent surface leakage currents across the circuit board material. This isolation is particularly effective when the guard traces are left unmasked by solder resist to maximize surface contact.
Routing Geometry
Optimal shielding requires that the width and spacing of the protective line be designed with care. While a wider trace provides better shielding, it consumes valuable board real estate and can alter the characteristic impedance of the protected signal line. Designers often specify a width equal to the signal trace width and locate the shielding trace as close to the signal as manufacturing limits allow.
Design Drawback
Adding these copper lines can increase board area and design complexity. They must be continuous and properly stitched to the ground plane with multiple vias to avoid acting as resonant antennas.